• PHG63A - For separating ball joints and tie rods
• PHG64A - Shears ball joint rivets
• PHG76A - For bushing cutting
• PHG21 - For bushing cutting, when extra reach is needed
• PHG57A - For panels cutting and sheet metal cutting
• PHG73A - For punching out pins and other driving applications
• PHG58B - For normal chisel cutting applications, when extra reach is needed
• PHG111 - Remove and install tube-hinge pins on car and truck doors
• PHG95A - Punches 3/16" diameter starting hole in sheet metal to prepare it for use with CJ107 and CJ114 Body Dent Pullers
• PHG65A - For cutting the muffler flange
• PHG87A - For removing the tail pipe
• PH201 - Projecting rods chip away rust and scale. Use only at low pressure
• PHG74A - For 3/16" stem
| |
|
|
|
Set Contains: |
PHG1005AK |
PHG1055K |
PHG1066K |
| Stock No. |
Description |
Application |
Length,
inches |
Tip, inches |
|
|
|
| PHG63A |
Air Hammer Ball Joint/Tie Rod Separator |
For separating ball joints and tie rods |
7-3/8 |
13/16 opening |
|
|
|
| PHG64A |
Air Hammer Bent End Chisel |
Shears ball joint rivets |
10-1/2 |
5/8 |
|
|
|
| PHG76A |
Bushing Cutter |
For bushing cutting |
6-1/4 |
1/2 |
|
|
|
| PHG21 |
Offset Bushing Splitter |
For bushing cutting, when extra reach is
needed |
8-3/8 |
5/8 |
|
|
|
| PHG57A |
Air Hammer Double Bladed Panel Cutter |
For panels cutting and sheet metal cutting |
6 |
3/4 |
• |
• |
|
| PHG73A |
Air Hammer Drift Punch |
For punching out pins and other driving
applications |
6-1/2 |
1/2 |
|
• |
• |
| PHG58B |
Air Hammer Flat Chisel |
For normal chisel cutting applications, when
extra reach is needed |
10 |
3/4 |
|
|
• |
| PHG111 |
Hinge Pin Driver |
Remove and install tube-hinge pins on car
and truck doors |
7-3/8 |
0.237 |
|
|
|
| PHG95A |
Hole Punch |
Punches 3/16" diameter starting hole in
sheet metal to prepare it for use with CJ107
and CJ114 Body Dent Pullers |
5-5/8 |
– |
|
|
|
| PHG65A |
Outside Cutter |
For cutting the muffler flange |
8-5/8 |
7/8 |
|
|
|
| PHG87A |
Muffler Cutter |
For removing the tail pipe |
8-3/4 |
7/8 |
|
|
|
| PH201 |
Needle Scaler |
Projecting rods chip away rust and scale.
Use only at low pressure |
7-13/16 |
– |
|
|
|
| PHG74A |
Riveter |
For 3/16" stem |
5-13/16 |
1/2 |
|
|
|
|
